A pendulum clock you can open up: tune it, change its wheels and hear it keep time.
Rate
This clock is measuring
measuring
your clock --:--:-- real --:--:--
Escapement
- Amplitude
- -
- Beat
- -
- Beat error
- -
lock impulse drop
Train check
- seconds hand: once every 60 s
- minute hand: once every 60 min
- hour hand: once every 12 h
Workbench
Change the layout, the drive, the escapement and the beat, then save, share or export the clock. Open the gear lab.
How it's built
The pendulum and the escape wheel are two bodies in a rigid-body simulation that runs 2,000 steps a second in a Web Worker. Each escape-wheel tooth is a point that meets a ruby pallet polygon: it lands, locks, slides down the impulse face and drops. The pendulum feels gravity, a little damping and those contacts, so the amplitude, the beat and the rate in seconds a day are measured from what it does, not drawn.
The gear train is a kinematic reduction: exact integer ratios, an efficiency per mesh and a reflected inertia at the escape wheel. Only the escapement has contact dynamics. Teeth are involute or cycloidal profiles generated from the module and tooth count (the cycloidal face is an epicycloid rolled by half the mating pinion's pitch radius). The movement is drawn from the same polygons the physics uses. This is a model, not a certificate: the rate is what the simulated clock does, and a real clock will differ.
The pendulum's centre of oscillation is calibrated by a fixed 0.36 mm offset so the demo keeps time at 993 mm: the bob is not a point mass. Layout checks (overlap, baseplate, pinion size, motion work) run on the same geometry; the clock does not run while a part is illegal. Share links hold the whole clock in the address, deflated and versioned, and are validated like any file. The laser-cut SVG is drawn from the polygons the screen uses, in true millimetres.